Manual
Table Of Contents
- Chapter 1 Aircraft
- Chapter 2 Remote Controller
- Chapter 3 Smart Battery
- Chapter 4 Autel Enterprise App
- Chapter 5 First Flight
- 5.1 Instructions for First Flight
- 5.2 Flight Precautions
- 5.3 Pre-Flight Preparations
- 5.3.1 Unpacking
- 5.3.2 Charging
- 5.3.3 Preparing the Aircraft
- 5.3.4 Installing/Removing Propellers
- 5.3.5 Preparing the Remote Controller
- 5.3.6 Login, Pairing, Activation (activation only upon first use)
- 5.3.7 Novice Guide (first time use only)
- 5.3.8 Reconnect the aircraft (not required by default, required after disconnection)
- 5.4 Pre-Flight Inspection
- 5.5 Basic Flight Process
- Chapter 6 Firmware Update and Maintenance
- Appendix A Product Specifications
Chapter 5 First Flight 83
EVO Max 4T User Manual
5) Please refer to "5.5.1 Start/Stop the Aircraft" and "5.5.2 Takeoff/Landing the Aircraft" to
use the remote controller to start the aircraft and take off.
6) Please refer to "5.5.3 Control the Aircraft (Default Mode 2)" to control the aircraft
carefully.
7) Please refer to "5.5.2 Takeoff/Landing the Aircraft" to land the aircraft, and then turn off
the motors.
5.5.1 Start/Stop the Aircraft
Start the Aircraft
Power on the aircraft, the aircraft will automatically perform self-check. Then
simultaneously move the left and right command sticks diagonally inward or outward for 2
seconds, as shown in Figure 5-5.
or
Figure 5-5 Start the Aircraft
Stop the Aircraft
After the aircraft starts, the following two methods can be used to stop the aircraft.
Method 1
When the flight is in landing state, pull the throttle stick (left command stick) as shown until
the motors are turned off.
Figure 5-6 Stop the Aircraft (left command stick straight up)
Method 2
When the flight is in landing state, move the left and right command sticks inward or
outward until the motors are turned off.
or
Figure 5-7 Stop the Aircraft (move the left and right command sticks diagonally inward or
outward)