Manual

82 Chapter 5 First Flight
EVO Max 4T User Manual
propellers and arms are fully extended.
3) Make sure that all aspects of the aircraft, including the lens of the gimbal, the lens of
the OA sensor, and the auxiliary light are free from foreign objects, dirt, or fingerprints,
and are not blocked by loads on the fuselage.
4) Make sure that the protective cover of the gimbal has been removed and the three-axis
movement of the gimbal is in a normal state.
5) Make sure that the microSD card slot and relevant interfaces are covered tightly,
otherwise performance will be affected.
6) Make sure the antenna of the remote control is deployed.
7) Place the aircraft in an open and flat area outdoors and ensure that there are no
obstacles, buildings, trees, etc. around. The user should stand at least 3 meters away
from the tail of the aircraft when operating.
8) Make sure that after the aircraft is powered on, the aircraft and the remote controller
are connected, and the aircraft motors, gimbal, and camera are working normally.
9) Make sure that all warnings and errors displayed on the Autel Enterprise App are
handled.
10) Enter the Autel Enterprise App setting page to set the flight control parameters,
obstacle avoidance system, joystick mode and other related flight safety parameters,
and be familiar with the flight operation; ensuring that the parameter settings meet
your own needs and guarantee flight safety.
11) If multiple aircrafts are flying at the same time, please keep an appropriate air
distance to avoid any accidents.

Before powering on the aircraft, please ensure that the battery is installed in place (the
edge of the battery is closely attached to the fuselage after installation), so as to avoid the
battery potentially falling during flight and causing flight safety accidents.

Only use accessories provided with the aircraft or
sold or authorized for use with the
aircraft. Using accessories that are not officially certified may pose a serious safety risk
and void the product warranty.
5.5 Basic Flight Process
The aircraft provides three command stick modes: Mode 1, Mode 2, and Mode 3. Each
mode controls the aircraft differently. The default mode is Mode 2. The user can switch the
mode in the Autel Enterprise App according to their control habit (for a detailed operation
method of the switch, please refer to Chapter 4 of the Autel Enterprise app: "4.3.3 Remote
Controller Settings".
The following is the basic operation of product flight.
1) Please refer to "5.3 Pre-Flight Preparations" to complete the preparations before flight.
2) Place the aircraft in an open area and stand at least 3 meters away from the rear arms
of the aircraft.
3) Press and hold the battery power button for 3s to turn on the power of the aircraft, wait
for the rear arm LED indicators to turn green and flash slowly (indicating that the
current status is normal).
4) Long press the power button for 3s to turn on the remote controller.