Manual

Chapter 5 First Flight 81
EVO Max 4T User Manual
3) Enter the "Autel Robotics
Care" interface, and choose
whether to purchase
according to your needs.
5.3.7 Novice Guide (first time use only)
When you enter the Enterprise App for the first time, a novice guide will appear. Please
learn the introduction and follow the tips on the screen until you enter the main interface.
5.3.8 Reconnect the aircraft (not required by default, required after
disconnection)
The remote controller has been paired with the EVO Max 4T at the factory, and there is no
need to connect it again after powering on. Normally, after completing the activation process,
you can directly use the remote controller. However, if the aircraft disconnects accidentally or is
unintentionally operated incorrectly by the user, the aircraft needs to be re-connected. For
detailed operation methods, please refer to "2.2.5 Pairing (Connecting to Aircraft)" in Chapter 2
Remote Controller.

When pairing, please keep the remote controller and aircraft close together, at most
50cm apart.
5.4 Pre-Flight Inspection
Follow the steps below to perform a comprehensive Pre-Flight check:
1) Make sure the batteries of the aircraft and remote controller are fully charged, paying
attention to the battery of the aircraft to ensure it is installed in place (the edge of the
battery must be closely attached to the fuselage after installation).
2) Make sure that the propellers of the aircraft are installed tightly without damage or
deformation, the motor and propellers are clean and free of foreign objects, and the