Manual
Table Of Contents
- Chapter 1 Aircraft
- Chapter 2 Remote Controller
- Chapter 3 Smart Battery
- Chapter 4 Autel Enterprise App
- Chapter 5 First Flight
- 5.1 Instructions for First Flight
- 5.2 Flight Precautions
- 5.3 Pre-Flight Preparations
- 5.3.1 Unpacking
- 5.3.2 Charging
- 5.3.3 Preparing the Aircraft
- 5.3.4 Installing/Removing Propellers
- 5.3.5 Preparing the Remote Controller
- 5.3.6 Login, Pairing, Activation (activation only upon first use)
- 5.3.7 Novice Guide (first time use only)
- 5.3.8 Reconnect the aircraft (not required by default, required after disconnection)
- 5.4 Pre-Flight Inspection
- 5.5 Basic Flight Process
- Chapter 6 Firmware Update and Maintenance
- Appendix A Product Specifications
80 Chapter 5 First Flight
EVO Max 4T User Manual
For detailed operation methods, please refer to "2.2.4 Adjusting the Antenna Position" in
Chapter 2 Remote Controller.
When the remote controller is disconnected from the aircraft and the screen is in standby
status for 50 minutes, the remote controller will automatically power off.
5.3.6 Login, Pairing, Activation (activation only upon first use)
When using EVO Max 4T for the first time, you need to activate the product after
connecting to Wi-Fi, and then choose whether to purchase the "Autel Robotics Care" service
according to your needs. The detailed process is shown in Table 5-6 below.
Table 5-6 Login, Pairing, Activation
Step Diagram
1)
Connect the remote
controller to Wi-Fi.
2)
According to the notices,
read and agree to the user
agreement and privacy
policy (when you use the
remote controller for the
first time, you need to
complete the activation
process before it can be
used normally), check "I
have read and agree to
abide by the above terms
and rules", and click
"Activate " button to
activate the product.