Manual
Table Of Contents
- Chapter 1 Aircraft
- Chapter 2 Remote Controller
- Chapter 3 Smart Battery
- Chapter 4 Autel Enterprise App
- Chapter 5 First Flight
- 5.1 Instructions for First Flight
- 5.2 Flight Precautions
- 5.3 Pre-Flight Preparations
- 5.3.1 Unpacking
- 5.3.2 Charging
- 5.3.3 Preparing the Aircraft
- 5.3.4 Installing/Removing Propellers
- 5.3.5 Preparing the Remote Controller
- 5.3.6 Login, Pairing, Activation (activation only upon first use)
- 5.3.7 Novice Guide (first time use only)
- 5.3.8 Reconnect the aircraft (not required by default, required after disconnection)
- 5.4 Pre-Flight Inspection
- 5.5 Basic Flight Process
- Chapter 6 Firmware Update and Maintenance
- Appendix A Product Specifications
Chapter 5 First Flight 79
EVO Max 4T User Manual
remove the propeller.
Before installing or removing propellers, make sure the aircraft is powered off.
When installing or removing propellers, it is recommended to wear protective gloves.
Do not touch spinning propellers or motors.
Before flying, check that each propeller is securely installed.
Do not fly if any propeller is broken.
Before testing the motor, make sure the propeller is removed.
5.3.5 Preparing the Remote Controller
Table 5-5 Preparing the Remote Controller
Step Diagram
1)
Removing/installing the
command sticks: Take and
install the command sticks
from the handle on the
back of the remote
controller.
2)
Power on the remote
controller: press and hold
the power button on the
top of the remote
controller for 3 seconds to
turn it on.
3)
Unfolding the antennas:
When using it for the first
time, the antenna of the
remote controller is in the
storage state and needs to
be unfolded.
or
Adjusting the position of the antenna can improve the image transmission signal quality.