Manual

Chapter 4 Autel Enterprise App 45
EVO Max 4T User Manual
4.3.3 Remote Controller Settings
Click " " to enter the "RC Settings" interface, the user can set the command stick mode,
EXP, and also support the calibration of the remote controller, as shown in Figure 4-4.
Figure 4-4 "RC Settings" interface
 Set Command Stick Mode
After clicking "Stick Mode", select one of Mode 1, Mode 2, and Mode 3. For the differences
between the three joystick modes, please refer to "2.4.2 Set Command Stick Modes" in Chapter
2 Remote Controller.
 Remote Calibration
Please refer to "2.2.7 Remote Controller Calibration" in Chapter 2 Remote Controller.
 Set Custom C1/C2 Buttons
Click "Custom RC Buttons", and then click the drop-down list of C1 and C2, and select the
customized function according to the needs.
 Set the EXP of the remote controller
After clicking "EXP", drag the coordinate system curves of "Ascent", "Turn Right",
"Forward/Move right", or input coefficients (range 0.2-0.7) in each edit box. The X-axis is the
physical output of the joystick, and the Y-axis is the logical output of the joystick, that is: the
X-axis represents the movement generated by the current joystick move, and the Y-axis
represents the actual response strength of the current aircraft. When the coefficient is 0.2, the
slope of the curve increases gradually, which is convenient for fine-tuning; when the coefficient
is 0.7, the slope of the curve gradually decreases, and the aircraft responds strongly when the
joystick is slightly moved. Click "Reset EXP" to reset the EXP parameters.