Manual
Table Of Contents
- Chapter 1 Aircraft
- Chapter 2 Remote Controller
- Chapter 3 Smart Battery
- Chapter 4 Autel Enterprise App
- Chapter 5 First Flight
- 5.1 Instructions for First Flight
- 5.2 Flight Precautions
- 5.3 Pre-Flight Preparations
- 5.3.1 Unpacking
- 5.3.2 Charging
- 5.3.3 Preparing the Aircraft
- 5.3.4 Installing/Removing Propellers
- 5.3.5 Preparing the Remote Controller
- 5.3.6 Login, Pairing, Activation (activation only upon first use)
- 5.3.7 Novice Guide (first time use only)
- 5.3.8 Reconnect the aircraft (not required by default, required after disconnection)
- 5.4 Pre-Flight Inspection
- 5.5 Basic Flight Process
- Chapter 6 Firmware Update and Maintenance
- Appendix A Product Specifications
Chapter 2 Remote Controller 19
EVO Max 4T User Manual
Figure 2-5 Install/Store Command Sticks
2.2.3 Checking Battery Level and Charge
Press and hold the power button on the top of the remote controller for 3 seconds to turn
it on. In the off state, short press the power button of the remote controller for 1 second, and
the power indicator light will display the power of the remote controller, and the remaining
power, as shown in Figure 2-6:
When the controller is on, users can check the current battery level on the top status bar
of Enterprise APP, or by pulling down the top notification bar or entering th
e main
interface of the remote controller.
The function of viewing the battery percentage can be enabled on the remote controller
main interface ("Settings" > "Battery" > "Battery Level").
Please connect the official remote controller charger to the USB Type-C port of the device
by using the remote controller charging cable. Please refer to "
2.1.1 Remot
e Controller
Top-Down View" in Chapter 2 Smart Remote Controller and "5.3.2 Charging" in Chapter 5
First Flight.
Figure 2-6 Check Power