Manual
Table Of Contents
- Chapter 1 Aircraft
- Chapter 2 Remote Controller
- Chapter 3 Smart Battery
- Chapter 4 Autel Enterprise App
- Chapter 5 First Flight
- 5.1 Instructions for First Flight
- 5.2 Flight Precautions
- 5.3 Pre-Flight Preparations
- 5.3.1 Unpacking
- 5.3.2 Charging
- 5.3.3 Preparing the Aircraft
- 5.3.4 Installing/Removing Propellers
- 5.3.5 Preparing the Remote Controller
- 5.3.6 Login, Pairing, Activation (activation only upon first use)
- 5.3.7 Novice Guide (first time use only)
- 5.3.8 Reconnect the aircraft (not required by default, required after disconnection)
- 5.4 Pre-Flight Inspection
- 5.5 Basic Flight Process
- Chapter 6 Firmware Update and Maintenance
- Appendix A Product Specifications
90 Chapter 6 Firmware Updates and Maintenance
EVO Max 4T User Manual
6.3.2 Aircraft Frame Inspection Items
Table 6-2 Aircraft Frame Inspection Items
Inspection Process
Aircraft Appearance
Make sure the exterior of the body is clean with no signs of damage or
deformation. If there are stains, please use a clean soft cloth to wipe
the body, especially the infrared sensing system and vision system
lenses and heat dissipation vents.
Aircraft Screws
Make sure that the screws of the whole fuselage are not falling off or
loosening, especially the connecting position of the motor and the arm
tube, and the connecting position of the arm and the fuselage.
Folding of Arms
1.
Make sure that the 2 screws on each arm, a total of 8 screws are
not loose or fall off.
2.
Make sure the arm attachments are free from breakage and cracks.
3.
Make sure that there is no obvious gap between the arm and the
fuselage after the arm is fully extended.
4.
Make sure that when folding the arms, the arms are folded in place,
smoothly and without jamming.
Arm Lights Make sure that the surface is free from dirt and damage.
Arm Legs
Make sure that the arm legs and the arm are firmly fixed, and the
screws are not loose or falling off.
Battery
Compartment
1.
Make sure the battery connector is free of dirt, water and
corrosion. If there are water stains and dust, wipe them clean.
2.
Make sure that the screws of the battery unlock buttons on both
sides are not loose or fall off.
3.
Make sure the battery unlock button springs back firmly.
4.
After installing the battery, make sure that the battery unlock
button can bounce back normally without obvious shaking.
Data Interface
1.
Wipe off foreign matter near the interface with gauze first.
2.
If the interface has been used, remove the connecting cable, and
then illuminate the interface with a light to check whether there are
foreign objects in the interface.
3.
If there are foreign objects, please use tweezers to remove them,
such as small stones and small pieces of paper.
4.
If there is a gel-like foreign matter in the interface, please wipe it off
with gauze.
5.
Put the aircraft in a tilted state, wit
h the interface facing
downwards, use gauze, a small brush and other tools to remove
other powdery foreign matter in the interface, pay attention to the
cleaning method, and clean the interface from the inside out.
microSD Card
Interface
1.
Make sure there are no foreign objects in the microSD card slot,
and the microSD card can be removed and installed normally.
2.
Make sure the microSD card reads and writes normally.
Waterproof Rubber
Plug
Make sure that the rubber plug is not damaged or loose.