User manual

47
NOTE
When not connected to the aircraft, the remote control beeps after 15
minutes of inactivity, and turns off automatically after 18 minutes.
3.2.3 Remote Control Calibration
If the Command Sticks are abnormal (for example, if the remote control is dropped
on the ground, or the aircraft’s flight direction does not match control inputs), it is
recommended to calibrate the remote control. You can calibrate the remote control
by using the Autel Explorer™ app (for details, see the App Manual) or according
to the following steps.
1.
Turn off the remote control. Press and
hold the Power Button ( ) and
Take-off/Landing Button ( )
simultaneously until the screen appears
as shown on the right. The four crossed
bars represent the left and right
Command Sticks. The horizontal bar
at the top is the Gimbal Pitch Dial.
2.
Release both Command Sticks and the
Gimbal Pitch Dial naturally to the
central position. The three middle
rounds on the remote control calibration
screen will be highlighted successively.
3.
Push and hold the Command Sticks in
each of the eight possible directions until
you hear a beep each time. Then, turn
the Gimbal Pitch Dial clockwise until
you hear a beep, and then
counterclockwise until you hear a beep.
4.
Calibration is completed when all the
bars on the screen are highlighted.
3.2.4 Pairing the Aircraft & Remote Control