User manual
Table Of Contents
- Chapter 1
- About the Manual
- 1.1 Instructions for the first flight
- Chapter 2
- Be familiar with your smart UAV.
- 2.1 Aircraft
- 2.2 Remote controller
- Chapter 3
- Flight preparation
- 3.1 Battery preparation
- 3.2 Remote controller preparation
- 3.3 Aircraft preparation
- Chapter 4
- Flight Operation
- 4.1 Check list before flight
- 4.2 Flight operation
- 4.2.1 Motor start and aircraft takeoff (American m
- 4.2.2 Manipulator control (American manipulator)
- Chapter 5
- Maintenance and service
- 5.2 Solutions to common faults
- 5.3 Storage and maintenance
- 5.4 Warranty
- 5.5 Customer service
- Chapter 6
- Annex
- 6.1 Authentication information and restricted area
- 6.2 Specifications
43
Important
Wear protective gloves when installing or disassembling the propeller.
Install propeller
1. Confirm that the aircraft has been turned off.
2. Select the propeller matched for each motor.
3. Forcibly press down the propeller and rotate it along the locking direction till that it is installed
firmly.
Propeller
With white mark
Without white mark
Schematic
diagram
Installation
position
Installed to the mount with white mark
Installed to the mount without white
mark
Legend
Locking direction: rotate the propeller to tighten it as shown in the figure.
Unlocking direction: rotate the propeller to remove it as shown in the figure.
Disassemble propeller
1. Turn off the aircraft.
2. Forcibly press down the propeller and rotate it along the unlocking direction till that it is
removed.
Important
Check to confirm that each propeller has been installed firmly before flight.
Do not use the damaged propeller for flight.
It is forbidden to touch the rotating propeller or motor.
It is always necessary to take down the propeller before motor test.