User manual
Table Of Contents
- Chapter 1
- About the Manual
- 1.1 Instructions for the first flight
- Chapter 2
- Be familiar with your smart UAV.
- 2.1 Aircraft
- 2.2 Remote controller
- Chapter 3
- Flight preparation
- 3.1 Battery preparation
- 3.2 Remote controller preparation
- 3.3 Aircraft preparation
- Chapter 4
- Flight Operation
- 4.1 Check list before flight
- 4.2 Flight operation
- 4.2.1 Motor start and aircraft takeoff (American m
- 4.2.2 Manipulator control (American manipulator)
- Chapter 5
- Maintenance and service
- 5.2 Solutions to common faults
- 5.3 Storage and maintenance
- 5.4 Warranty
- 5.5 Customer service
- Chapter 6
- Annex
- 6.1 Authentication information and restricted area
- 6.2 Specifications
42
3.3 Aircraft preparation
3.3.1 Extend aircraft
Take down and reinstall the gimbal protective cover
First take down the gimbal support, and turn on the aircraft. As shown in the figure below.
After the aircraft is used, the gimbal protective cover shall be reinstalled to prevent the gimbal
from damage.
Extend the arm and propeller
Please remember to always extend the arm of the aircraft before turning on the aircraft power
switch.
Please first extend the front arm, and then the rear arm.
Important
Before folding the arms, turn off the aircraft power switch.
3.3.2 Install the propeller
EVO II Enterprise use noise-reduction rapid-disassembled propellers.
Warning
Before installing or disassembling the propeller, please turn off the aircraft power switch.