User manual
Table Of Contents
- Chapter 1
- About the Manual
- 1.1 Instructions for the first flight
- Chapter 2
- Be familiar with your smart UAV.
- 2.1 Aircraft
- 2.2 Remote controller
- Chapter 3
- Flight preparation
- 3.1 Battery preparation
- 3.2 Remote controller preparation
- 3.3 Aircraft preparation
- Chapter 4
- Flight Operation
- 4.1 Check list before flight
- 4.2 Flight operation
- 4.2.1 Motor start and aircraft takeoff (American m
- 4.2.2 Manipulator control (American manipulator)
- Chapter 5
- Maintenance and service
- 5.2 Solutions to common faults
- 5.3 Storage and maintenance
- 5.4 Warranty
- 5.5 Customer service
- Chapter 6
- Annex
- 6.1 Authentication information and restricted area
- 6.2 Specifications
41
Remark
The batteries of the aircraft and the remote controller shall be always fully charged before
flying.
At most 90 minutes are required to fully charge the aircraft battery, and approximately 120
minutes are required for the remote controller.
After charging is complete, disconnect the charger from the aircraft battery/remote controller.
3.2 Remote controller preparation
3.2.1 Extend remote controller
The remote control is folded in the packing box. Please extend the antenna before use.
Antenna position adjustment
Please refer to Section 2.2.2.
3.2.2 Turn on/off remote controller
Power on/off
Press and hold the power button for 2s until you hear a short beep.
Important
Before the aircraft power switch is turned on, always turn on the remote control first.
Before the remote controller is turned off, always turn off the aircraft power switch first.
3.2.3 Aircraft and remote controller pairing
The remote controller and the aircraft have been paired in factory. If they need to be paired again,
please refer to Section 2.2.2 ( ).