User manual
Table Of Contents
- Chapter 1
- About the Manual
- 1.1 Instructions for the first flight
- Chapter 2
- Be familiar with your smart UAV.
- 2.1 Aircraft
- 2.2 Remote controller
- Chapter 3
- Flight preparation
- 3.1 Battery preparation
- 3.2 Remote controller preparation
- 3.3 Aircraft preparation
- Chapter 4
- Flight Operation
- 4.1 Check list before flight
- 4.2 Flight operation
- 4.2.1 Motor start and aircraft takeoff (American m
- 4.2.2 Manipulator control (American manipulator)
- Chapter 5
- Maintenance and service
- 5.2 Solutions to common faults
- 5.3 Storage and maintenance
- 5.4 Warranty
- 5.5 Customer service
- Chapter 6
- Annex
- 6.1 Authentication information and restricted area
- 6.2 Specifications
40
Charge the aircraft and the remote controller
1. Insert the charge wire by the following steps:
Aircraft battery: Insert the charge connector into the charge interface of the battery.
Battery level indicator: The LED indicators on the aircraft battery light up in order from left
to right to indicate the current battery level during the charging cycle, and turn off when the
battery is fully charged.
Battery level indicator status (Charging status)
- Green is normally on - Green is flashing
2. Remote controller: insert the Type-C power cable into the Type-C port of the remote
controller.