User manual
Table Of Contents
- Chapter 1
- About the Manual
- 1.1 Instructions for the first flight
- Chapter 2
- Be familiar with your smart UAV.
- 2.1 Aircraft
- 2.2 Remote controller
- Chapter 3
- Flight preparation
- 3.1 Battery preparation
- 3.2 Remote controller preparation
- 3.3 Aircraft preparation
- Chapter 4
- Flight Operation
- 4.1 Check list before flight
- 4.2 Flight operation
- 4.2.1 Motor start and aircraft takeoff (American m
- 4.2.2 Manipulator control (American manipulator)
- Chapter 5
- Maintenance and service
- 5.2 Solutions to common faults
- 5.3 Storage and maintenance
- 5.4 Warranty
- 5.5 Customer service
- Chapter 6
- Annex
- 6.1 Authentication information and restricted area
- 6.2 Specifications
39
Chapter 3
Flight preparation
The EVO Ⅱ Enterprise series is convenient and unique in design and is fully assembled before
delivery. To ensure the safe operation of the UAV, please read the following instructions and
warnings before the first flight.
3.1 Battery preparation
3.1.1 Install aircraft battery
1. Turn off the battery power switch before installing battery.
2. Insert the battery into the battery compartment. There will be clicking sound when the battery is
installed in place.
3.1.2 Disassemble aircraft battery
1. Turn off the aircraft battery power switch before taking out the battery.
2. Press the buckles at two sides of battery and slowly take out the battery.
3.1.3 Charging
The aircraft battery and remote controller can use the charger for charging. The two connectors are
connected with the charger. As shown in the figure below, the fixed plug is connected with the
aircraft battery, and USB charge wire is used for charging the remote controller.