User manual
Table Of Contents
- Chapter 1
- About the Manual
- 1.1 Instructions for the first flight
- Chapter 2
- Be familiar with your smart UAV.
- 2.1 Aircraft
- 2.2 Remote controller
- Chapter 3
- Flight preparation
- 3.1 Battery preparation
- 3.2 Remote controller preparation
- 3.3 Aircraft preparation
- Chapter 4
- Flight Operation
- 4.1 Check list before flight
- 4.2 Flight operation
- 4.2.1 Motor start and aircraft takeoff (American m
- 4.2.2 Manipulator control (American manipulator)
- Chapter 5
- Maintenance and service
- 5.2 Solutions to common faults
- 5.3 Storage and maintenance
- 5.4 Warranty
- 5.5 Customer service
- Chapter 6
- Annex
- 6.1 Authentication information and restricted area
- 6.2 Specifications
20
Important:
Please make sure that the ring at the front end of the gimbal is aligned with the two pins in
the gimbal compartment of the machine head.
Please make sure that the gimbal is in flush with the slot of the gimbal compartment.
2. Insert the connector cable port into its slot, and gently push it to the end when inserting. Place
the gimbal cover on the top of the gimbal compartment, and tighten the cover with a cross
screwdriver.
3. Insert a screw into a hole of the gimbal decorating part, and then screw it with a T6 screwdriver
until the screw is fixed but not being tightened. Repeat this step for other screws. Fully tighten the
two screws with the screwdriver.
4. Turn on the power switch of the aircraft. If the connector cable of the gimbal is connected
correctly, the gimbal will rotate automatically to carry out self inspection.