User manual
Table Of Contents
- Chapter 1
- About the Manual
- 1.1 Instructions for the first flight
- Chapter 2
- Be familiar with your smart UAV.
- 2.1 Aircraft
- 2.2 Remote controller
- Chapter 3
- Flight preparation
- 3.1 Battery preparation
- 3.2 Remote controller preparation
- 3.3 Aircraft preparation
- Chapter 4
- Flight Operation
- 4.1 Check list before flight
- 4.2 Flight operation
- 4.2.1 Motor start and aircraft takeoff (American m
- 4.2.2 Manipulator control (American manipulator)
- Chapter 5
- Maintenance and service
- 5.2 Solutions to common faults
- 5.3 Storage and maintenance
- 5.4 Warranty
- 5.5 Customer service
- Chapter 6
- Annex
- 6.1 Authentication information and restricted area
- 6.2 Specifications
14
G - Normally on
Calibration successful
R - Normally red
Calibration failed
Gesture instructions
R - Quick flash
Receive gesture instructions
2.1.3 Aircraft battery
The rechargeable lithium polymer battery used in the EVO II RTK series has the characteristics of
high energy density and large capacity. It shall be charged with the provided special charger.
Basic functions
① Disconnect button
② Battery level indicator
③ Power button
Turn on battery
The battery shall be turned off before it is installed. After installation, long press the power
button for 3s. The battery level indicator will indicate the current battery level.
Turn off battery
Long press the power button for 3s to turn off battery. If the battery has been installed on aircraft,
The first and last LED lights will flash for five times to remind the shutting down. After all
battery level indicators are turned off, take the battery out of the aircraft.
Check battery level
When the battery is turned off, press the power button for 1 second and then release it quickly to
check the battery level. LED will indicate the current battery level, as shown below.