Owner's Manual

Battery Safety
The
EVO
II
is
powered by a lithium-polymer battery. The misuse
of
Li-Po/Li-Ion batteries can be hazardous. As such, make sure to strictly
follow
all
the battery usage, charging and storage instructions below.
Lt
WARNING
Only use batteries and charging devices that came with the
aircraft or are sold by Autel Robotics for use with the
EVO
II.
Do not tamper with the battery pack or its charger.
Battery electrolytes are highly corrosive. If any electrolyte
comes
in
contact with your skin or your eyes, immediately
flush the affected area with clean running water and seek
medical attention.
Battery Usage
Always turn off the aircraft before installing or removing the battery.
Additional information:
Only use batteries and charging devices that came with the aircraft
or are sold or authorized by Autel Robotics for use with the
EVO
II.
Using unapproved batteries or charging devices may result
in
fire,
explosion, leakage,
or
other hazards. Autel Robotics will not be
liable for any consequences resulting from the use
of
third-party
batteries or charging devices.
Do not disassemble, open, crush, bend, deform, puncture, shred,
or otherwise intentionally cause damage
to
the battery. Doing so
may result
in
fire,
explosion, leakage, or other hazards.
If the battery starts
to
swell, smoke, leak, or show any signs
of
damage, stop using or charging it immediately and submerge
1t
in
a container of salt water.
Do
not expose the battery to temperatures below
-10°C
(14
°F) or
above
40
°C (104 °
F).
Exposing the battery to extreme tempera-
tures will reduce its lifespan and may result
in
fire,
explosion, or
other permanent damage.
Temperatures below
5°C
(41
°
F)
will cause the battery to discharge
faster.
Do
not use the battery
in
strong electrostatic or electromagnetic
environments.