EVO Nano Series User Manual
Table Of Contents
- User Manual
- EVO Nano Series
- Terms for Usage
- Trademark Information
- Copyright
- Disclaimer
- Data Storage and Use
- Table of contents
- Chapter 1 Read Instructions
- Chapter 2 Aircraft
- ① Propeller
- ④ Forward visual system
- ② Motor
- ⑤ Antenna
- ③ PTZ camera
- ⑥ Rear vision system
- ⑨ USB-C port
- ⑦ Power button
- ⑩ Rear LED indicator
- ⑧ Aircraft battery
- ⑪ SD card slot
- ⑫ Air outlet
- ⑬ Ultrasonic sensor
- ⑮ Air inlet
- ⑭ Downward vision system
- There is an LED indicator on the tail of the aircr
- Status Definition of Flight LED Indicator
- Back LED Indicator
- Meaning
- Normal status
- Green light flashes slowly (1 flash every 2 second
- Aircraft in GPS mode
- Yellow light flashes slowly (1 flash per second)
- Aircraft in ATTI mode
- Pairing
- Green light flashes quickly
- Aircraft and remote controller are pairing
- Green light stays on for 5 seconds
- Pairing successful
- Red light stays on for 5 seconds
- Pairing failed
- Compass calibration
- Yellow light is on
- Starting compass calibration
- Yellow light is on
- Calibration failed
- Green light is on
- Calibration successful
- Warning
- Yellow light flashes slowly (1 flash per second)
- Low battery warning
- Red light flashes slowly (1 flash per second)
- Critical low battery alert
- Updating
- Green light flashes quickly
- Aircraft is updating
- Green light is is on
- Update successful
- Yellow light flashes slowly (1 flash per second)
- Update failed
- The battery for EVO Nano is 2250mAh and has the ra
- The battery indicator is divided into LED 1, LED 2
- Chapter 3 Remote controller
- Chapter 4 Autel Sky App
- Chapter 5 Flight
- 1) As shown in figure, press the left and right st
- 2) Slowly push up the left stick.
- 1) Press and slide the one-click takeoff button (
- 2) The aircraft will automatically rise to the hei
- Class I: main airport & low-altitude area for mann
- Class II: Sensitive area or organization & militar
- Chapter 6 Maintenance and service
- Method 1: download firmware upgrade package from A
- Method 2: download firmware upgrade package from t
- Chapter 7 Technical Specification
Photo format
JPG(8-bit) / DNG(10-bit) / JPG+DNG
Photo resolution
48MP: 8000x6000 (4:3)
12MP(default): 4000x3000 (4:3)
4K: 3840x2160 (16:9)
Photo shooting mode
Single shot
Burst shooing: 3/5
Auto exposure bracketing(AEB): 3/5 shots
Interval: 2s/3s/4s/5s(default)/6s/.../60s
(DNG min 5s)
HDR imaging: 3840x2160
Video coding format
H265/H264
Video resolution
3840x2160 p30/25/24
2720x1528 p30/25/24
1920x1080 p60/50/48/30/25/24
HDR:
3840x2160 p30/25/24
2720x1528 p30/25/24
1920x1080 p60/50/48/30/25/24
Max bitrate
100Mbps
Timelapse
Original image: 3840*2160, JPG/DNG
Video: 4K P25
Panorama
Horizontal/Vertical/Wide-angle/Spherical
Original image: 4000*3000, JPG/DNG
Supported file system
Fat32, exFat
Video format
MP4/MOV (8-bit)
WIFI transfer
20MB/s
Camera
(Nano+)
Sensor
CMOS: 1/1.28 inch
Effective pixels: 50MP
Pixel size: 2.44μm*2.44μm (Bin2)
Lens
FOV: 85°
Equivalent focal length: 23mm
Aperture: f/1.9
Focus range: 0.5m ~ ∞
Focus mode: PDAF+CDAF/MF
Shooting mode
Automatic mode (P gear): EV adjustable,
ISO/Shutter automatic
Manual mode (M gear): ISO/Shutter
adjustable, EV not adjustable
Shutter priority (S file): Shutter/EV
adjustable, ISO automatic
ISO range
Video: ISO100 ~ ISO6400