EVO Nano Series User Manual
Table Of Contents
- User Manual
- EVO Nano Series
- Terms for Usage
- Trademark Information
- Copyright
- Disclaimer
- Data Storage and Use
- Table of contents
- Chapter 1 Read Instructions
- Chapter 2 Aircraft
- ① Propeller
- ④ Forward visual system
- ② Motor
- ⑤ Antenna
- ③ PTZ camera
- ⑥ Rear vision system
- ⑨ USB-C port
- ⑦ Power button
- ⑩ Rear LED indicator
- ⑧ Aircraft battery
- ⑪ SD card slot
- ⑫ Air outlet
- ⑬ Ultrasonic sensor
- ⑮ Air inlet
- ⑭ Downward vision system
- There is an LED indicator on the tail of the aircr
- Status Definition of Flight LED Indicator
- Back LED Indicator
- Meaning
- Normal status
- Green light flashes slowly (1 flash every 2 second
- Aircraft in GPS mode
- Yellow light flashes slowly (1 flash per second)
- Aircraft in ATTI mode
- Pairing
- Green light flashes quickly
- Aircraft and remote controller are pairing
- Green light stays on for 5 seconds
- Pairing successful
- Red light stays on for 5 seconds
- Pairing failed
- Compass calibration
- Yellow light is on
- Starting compass calibration
- Yellow light is on
- Calibration failed
- Green light is on
- Calibration successful
- Warning
- Yellow light flashes slowly (1 flash per second)
- Low battery warning
- Red light flashes slowly (1 flash per second)
- Critical low battery alert
- Updating
- Green light flashes quickly
- Aircraft is updating
- Green light is is on
- Update successful
- Yellow light flashes slowly (1 flash per second)
- Update failed
- The battery for EVO Nano is 2250mAh and has the ra
- The battery indicator is divided into LED 1, LED 2
- Chapter 3 Remote controller
- Chapter 4 Autel Sky App
- Chapter 5 Flight
- 1) As shown in figure, press the left and right st
- 2) Slowly push up the left stick.
- 1) Press and slide the one-click takeoff button (
- 2) The aircraft will automatically rise to the hei
- Class I: main airport & low-altitude area for mann
- Class II: Sensitive area or organization & militar
- Chapter 6 Maintenance and service
- Method 1: download firmware upgrade package from A
- Method 2: download firmware upgrade package from t
- Chapter 7 Technical Specification
The automatic landing can also be used in ATTI mode. However, the aircraft may drift in
this mode, so its flight height shall be monitored.
In the case of low battery alarm, the rear LED of the aircraft will flash red. At this time, it
is necessary to return the safe landing point as soon as possible.
5.4 Flight restrictions
According to the controlled airspace and UAV management regulations of the ICAO and the
air traffic management authorities of each country, UAV must fly in the specified airspace.
For the sake of flight safety, the flight restrictions are activated by default, including height
and distance limits and flight restriction in special area.
Remark
Operator shall abide by all the local rules and regulations concerning flight.
5.4.1 Classification of restricted area
The restricted area is classified into two.
Class I: main airport & low-altitude area for manned aircraft
1. Restricted area
A circular area centered on this area and with a radius of 2.4km (subject to government rules)
2. Height limit area
An annular area centered on this area and with a radius of 2.4~8km. The flight height of the
aircraft is limited and such height limit varies with the radius. When the radius decreases from
8km to 2.4km, the maximum flight height will decrease from 120m to 10.5m.
3. Warning area
APP will give a warning information when the aircraft enters the area of 8.1km from the
airport.
Class II: Sensitive area or organization & military area & border between countries
1. Restricted area