Owner's Manual

100°
9. FREQUENCY MATCH
~ NOTE:
LED indicator will flash while
charging
• Do not use other communi-
cation equipment which has
the same frequency band at
the same time, to avoid the
interference to the Smart
Controller signal.
• During operation, the Autel
Explorer app, will prompt
the user when the image
transmission signal is poor.
Adjust the antenna angles
according to the prompts to
ensure the Smart Controller
and aircraft have the best
communication range.
When the Smart Controller and the aircraft are purchased as a set, the Smart
Controller has been matched to the aircraft at the factory, and it can be used
directly after the aircraft is activated.
If purchased separately, please use the following methods to link.
1. Press (short press) the linking button next to the USS port on the right
side of the aircraft body to put the aircraft into the linking mode.
2. Power on the Smart Controller and run the Autel Explorer app, enter the
mission flight interface, click the gear icon in the upper right corner, enter
the settings menu, click "remote control-> data transmission and image
transmission linking> start linking", wait a few seconds until the data
transmission is set correctly and the linking is a success.
7