User's Manual

90
Figure 6-21 Sample Copy by OBD Screen
When the programming is complete, the programmed ID will appear to the
right of the FR column.
By using Copy by OBD, the sensor ID that is retrieved from TPMS ECU is
programmed to the new MX-Sensor.
In this case, there is no need to perform the Relearn function to write the ID
into the ECU.
It is highly recommended to use Copy by OBD, if available, to program new
MX-Sensors for the IDs are definitely correct and there is no need for
Relearn.
Copy by Input
The Copy by Input allows users to program a new MX-Sensor with the ID
of an original TPMS sensor.
Select one sensor position and place a MX-Sensor near the TPMS antenna
of the tablet (the top right corner), and then tap Copy by Input to program
the new MX-Sensor.