User's Manual

89
Figure 6-20 Sample Copy by Active Complete Screen
When the programming is complete, the programmed ID will appear to the
right of the FL column.
By using Copy by Active, the sensor ID that is retrieved from sensor
activation is programmed to the new MX-Sensor.
Because the IDs of the original sensor and the new MX-Sensor are the
same and the ID has already be recognized by the vehicle ECU, so there is
no need to perform the Relearn function to write the ID into the ECU.
But if the IDs retrieved from sensor activation and TPMS ECU are different,
please use Copy by OBD to program the IDs saved in the ECU to the new
MX-Sensor.
Copy by OBD
By using this function, the tablet will program the sensor IDs retrieved from
the ECU of the test vehicle to the new MX-Sensors.
Select one sensor position and place a MX-Sensor near the TPMS antenna
of the tablet (the top right corner), and then tap Copy by OBD to program
the new MX-Sensor.