User's Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using This Manual
- 2 General Introduction
- 3 Getting Started
- 4 Diagnostics
- 5 Service
- 6 TPMS
- 7 Data Manager
- 8 Settings
- 9 Update
- 10 VCI Manager
- 11 Shop Manager
- 12 Academy
- 13 Remote Desk
- 14 MaxiFix
- 15 Support
- 16 Quick Link
- 17 Function Viewer
- 18 Maintenance and Service
- 19 Compliance Information
- 20 Warranty
62
and tap Yes to confirm. See Vehicle Identification on page 21 for detail.
3. Tap the service you want in the SAS function list, the list may vary for
different vehicles being tested.
Figure 5-18 Sample SAS Function Menu
Steering Angle Sensor Calibration
This function allows users to perform steering angle sensor calibration and
clear records. The function options vary with the vehicles being tested.
1) Tap Steering Angle Sensor Calibration from the SAS function menu
to enter the function screen.
2) Follow the on-screen instructions to set the ignition on/off as guided.
The vehicle battery voltage signal should be in the range 12.5 – 13.5
volts to proceed this service, otherwise the scan tablet will display a
warning message.
3) Make sure the steering wheel is in the central position and the front
wheels are in the straight position. Then tap OK to proceed.