User's Manual

19
NOTE
When both the communication methods are applied at the same time, the
MaxiCheck system will use the USB communication as the default priority.
No Communication Message
A. If the Display Tablet is not connected to the MaxiVCI Mini correctly, an
“Error” message may display. This indicates that the Display Tablet
cannot access the vehicle control module. In this case, please do the
following check-ups:
 Check if the MaxiVCI Mini is powered up.
 Check if the MaxiVCI Mini is properly positioned.
 Check if the Connection LED on the MaxiVCI Mini is illuminated for
BT or USB.
 In case of BT connection, check if the network is configured
correctly, or if the right MaxiVCI Mini has been paired up with the
Display Tablet.
 If during the diagnosis process, the communication is
suddenly interrupted due to the loss of signal, check if there is
any object that causes signal interruption.
 Try standing closer to the MaxiVCI Mini to obtain more stable
signals and faster communication speed.
 In case of USB connection, check the cable connection between
the Display Tablet and the MaxiVCI Mini.
 Check if the Power LED on the MaxiVCI Mini is flashing red and if
so, it indicates there is a hardware problem with the MaxiVCI Mini,
in this case contact technical support for help.
B. If the MaxiVCI Mini is unable to establish a communication link, a
prompt message displays with check instructions. The following
conditions are the possible causes:
 The MaxiVCI Mini is unable to establish a communication link with
the vehicle.
 The system selected for testing is not equipped on the vehicle.
 There is a loose connection.
 There is a blown vehicle fuse.