User's Manual

120
BT Pairing
The MaxiVCI Mini needs to be connected to a vehicle, so that it is powered
up during the synchronization procedure. Make sure the Display Tablet has
sufficient battery or is connected to an external power supply.
 To pair the MaxiVCI Mini with the Display Tablet
1. Power on the Display Tablet.
2. Insert the 16-pin vehicle data connector of the MaxiVCI Mini to the
vehicle data link connector (DLC).
3. Tap the VCI Manager application on the MaxiCheck Job Menu of
the Display Tablet.
4. Select BT from the connection mode list.
5. Tap the Scan button at the top right corner. Now the device starts
searching for available pairing units.
6. The device name may display as Maxi suffixed with a serial
number. Select the required device for pairing.
7. When paring is successfully done, the connection status displayed
to the right of the device name is shown as Paired.
8. Wait a few seconds, and the VCI button on the system Navigation
bar at the bottom of the screen shall display a green tick icon and
the Connection LED on the MaxiVCI Mini illuminates solid blue,
indicating the Display Tablet is connected to the MaxiVCI Mini, and
is ready to perform vehicle diagnosis.
9. Tap the paired device again to unpair it.
10. Tap the Home button on the top left to return to the MaxiCheck Job
Menu.
NOTE
A MaxiVCI Mini can be paired to only one Display Tablet each time, and
once it’s been paired, the device will not be discoverable for any other unit.
Update
Please refer to Update via Display Tablet on page 118 for details.