User's Manual

39
parameters.
NOTE
This mode supports Graph Merge for 2 to 3 parameter items only, so select no less
than 2 or more than 3 items each time when making graph merge.
 To cancel Graph Merge mode, tap the drop-down button on the right side of the
parameter name, and select a data display mode.
 Show Selected/Show All – taps it to exchange between the two options; one
displays the selected parameter items, the other displays all the available
items.
 Setting – taps it to open a setting screen, which allows you to set the trigger
mode, recording duration, and various threshold values for data recording,
and make other controls.
Figure 4-12 Sample Setting Mode in Live Data
There are four navigation buttons on top of the Setting mode screen.
 Range – displays the configuration screen on which you can set the
threshold values, an upper limit and a lower limit, for triggering the buzzer
alarm. This function is only applied to the Waveform Graph display mode.
a) MIN – taps it to open a virtual keyboard to enter the required lower
limit value.
b) MAX – taps it to open a virtual keyboard to enter the required upper
limit value.
c) Buzzer Alarm – switches the alarm on and off. The alarm function
makes a beep sound as a reminder whenever the data reading
reaches the preset minimum or maximum point.
 To set threshold limits for the parameter values