User's Manual

73
8. Tap Finish on the top right side to complete the
calibration. If all scale icons (A, E, T and R) fall in the
middle position, the remote controller is ready for
use.
3) Switch and Button Test
The Switch and button Test section allows users to test
the 2 switches on the front top of the remote controller
and 2 buttons at the bottom of the remote controller.
The upper switch group allows testing of the Smart
Control Switch which includes Normal, IOC and Go
Home modes.
The lower switch group allows testing of the Flight Mode
Switch which includes GPS, ATTI and ATTI modes.
The bottom two buttons allows testing of the 1-click
Take-off and Landing buttons.
When pushing the switch on the remote controller to a
specific position or press the specific button, the
corresponding mode will be highlighted accordingly.
Test both switches and buttons in each of their positions
successively.
Figure 4-19 Switch and Button Test – in Normal Pos.