User's Manual

84
Chapter 10 VCI Manager Operations
This application allows you to check the status of and to pair the MaxiSys
TM
Display
Tablet to the VCI device, either the J2534 Programming Device or the Bluetooth
Diagnostic Interface.
Figure 10-1 Sample VCI Manager Screen
1. Connection Mode – there are two connection modes available for selection. The
connection state is displayed alongside.
 Bluetooth Paring – when paired to a Bluetooth device, the connection state
displays as Paired; otherwise it displays as Unpaired.
 Wired Network Connection (for J2534 ECU Programming Device only) –
when connected to a Local Area Network, the connection status displays as
connected; otherwise it displays as Disconnected.
 Select a connection mode to manage and set up connection.
2. Settings – this section allows you to manage wireless pairing or set up network
connection.
 Bluetooth Setting – searches and displays the type and a partial serial
number for all of the devices available for pairing. Tap a required device to
start pairing.
 Ethernet Setting – allows you to perform network configuration.