User's Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using This Manual
- 2 General Introduction
- 3 Getting Started
- 4 Read DTCs
- 5 Clear DTCs
- 6 Repair Reports
- 7 Smog Check
- 8 Mode 6
- 9 Freeze Frame
- 10 Vehicle Info
- 11 MIL Status
- 12 Live Data
- 13 Me
- 14 Product Troubleshooting
- 15 Compliance Information
- 16 Warranty and Service
24
Firmware Update
This options allows you to update the firmware of the MaxiAP AP100
connector. Connect the device with the Internet and then tap
Me>Settings>Firmwadumre Update to update if new firmware version is
available.
Unit
This option allows you to adjust the measurement unit for the diagnostic
system. You can tap Imperial or Metric to switch between these two
measurement units.
Software Update
For Android devices, this option allows you to update the software when a
new version is available. For iOS devices, software update is notified in the
Updates section of the App Store.
Figure 13-6 Sample Firmware Update Screen