User's Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using This Manual
- 2 General Introduction
- 3 Getting Started
- 4 Read DTCs
- 5 Clear DTCs
- 6 Repair Reports
- 7 Smog Check
- 8 Mode 6
- 9 Freeze Frame
- 10 Vehicle Info
- 11 MIL Status
- 12 Live Data
- 13 Me
- 14 Product Troubleshooting
- 15 Compliance Information
- 16 Warranty and Service
23
Device Activate
The MaxiAP AP100 needs to be activated after first log in. Connect the
device with the MaxiAP AP100 connector and then tap Me>Settings>Device
Activate in the app to activate the device. Please refer to Powering Up on
page 6 for VCI connection details.
Figure 13-4 Sample Settings Screen
Figure 13-5 Sample Device Activate Screen