User's Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using This Manual
- 2 General Introduction
- 3 Getting Started
- 4 Read DTCs
- 5 Clear DTCs
- 6 Repair Reports
- 7 Smog Check
- 8 Mode 6
- 9 Freeze Frame
- 10 Vehicle Info
- 11 MIL Status
- 12 Live Data
- 13 Me
- 14 Product Troubleshooting
- 15 Compliance Information
- 16 Warranty and Service
11
5 Clear DTCs
There are two ways to clear trouble codes.
1. Tap Read DTCs, when the scan completes, tap Clear on the top and
pick the codes you want to clear. You can clear Engine codes, ABS
codes or both at the same time. Wait for codes to be cleared.
2. Clear codes directly from the Home screen without having to read
codes first. Again, you can clear Engine codes, ABS codes or both at
the same time. Now, wait for codes to be cleared.
In the Clear DTCs screen, you can tap Clear all or Choose to clear. Please
be reminded that this action will erase the DTCs and turn off MIL, but the
problems are still there.
NOTE
Most vehicles can have codes cleared with the engine running. However,
some vehicles such as doge require the engine to be off with the key in the
ACC position to clear codes.
Figure 5-1 Sample Clear DTCs Screen