User's Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using This Manual
- 2 General Introduction
- 3 Getting Started
- 4 Read DTCs
- 5 Clear DTCs
- 6 Repair Reports
- 7 Smog Check
- 8 Mode 6
- 9 Freeze Frame
- 10 Vehicle Info
- 11 MIL Status
- 12 Live Data
- 13 Me
- 14 Product Troubleshooting
- 15 Compliance Information
- 16 Warranty and Service
5
Wireless Communication
The MaxiAP AP100 supports BT communication. It can transmit vehicle
data to your iOS or Android devices without a physical connection. The
working range for BT communication is about 33 feet (about 10 m). A signal
lost due to moving out of range automatically restores itself when the device
is brought closer to the MaxiAP AP100 connector.
Power Source
The MaxiAP AP100 operates on 12-volt vehicle power, which it receives
through the vehicle data connection port. The unit powers on whenever it is
connected to an OBDII/ EOBD compliant data link connector (DLC).