User's Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using This Manual
- 2 General Introduction
- 3 Getting Started
- 4 Read DTCs
- 5 Clear DTCs
- 6 Repair Reports
- 7 Smog Check
- 8 Mode 6
- 9 Freeze Frame
- 10 Vehicle Info
- 11 MIL Status
- 12 Live Data
- 13 Me
- 14 Product Troubleshooting
- 15 Compliance Information
- 16 Warranty and Service
4
connected with the device.
B. Blue
Lights solid blue when the device is connected with the MaxiAP
AP100 via Bluetooth.
Flashes blue when the device is communicating with the MaxiAP
AP100, for example when the device is reading Engine DTCs.
C. Red
Lights solid red when the MaxiAP AP100 is updating the firmware
or the update failed.
NOTE
The power LED goes off when the MaxiAP AP100 disconnects with the
device for over 10 minutes and enters the standby mode with low power
consumption. The power LED comes back on with reconnection.
Technical Specifications
Table 2-1 Specifications
Item
Description
Communications
BT3.0 + BT4.0
Wireless Frequency
2.4 GHz
Input Voltage Range
9 VDC to 26 VDC
Supply Current
100 mA@12 V
Sleep Mode Current
3 mA@12 V
Operating Temp.
0°C to 50°C
Storage Temp.
-20°C to 70°C
Dimensions (L * W * H)
59.2 mm (2.33’’) * 48.5 mm (1.91’’) * 24.6 mm
(0.97’’)
Weight
35g (0.07 lb.)