User's Manual

38
Copy by OBD
This function allows users to write in the saved sensor information to MX-Sensor after
performing Read IDs from Vehicle in TPMS Diagnostic function.
Program One by One
1. Follow the steps in Auto Create to select MX-Sensor to enter the Programming
function. The OBD mark will appear on the right side of the screen (Figure 5-18).
After selecting the specific wheel and pressing the Y button, the Copy by OBD
option is available on the function menu (Figure 5-19).
Figure 5-18 Sample OBD Mark Screen
Figure 5-19 Sample Copy by OBD Screen
2. Select Copy by OBD, insert the correct MX-Sensor into the sensor slot, and then
press the Y button to start programming the saved sensor information to the
MX-Sensor. MX-Sensor that programmed in this way will bear the same ID saved in
the vehicle’s ECU, therefore there is no need for the vehicle to relearn the newly
programmed MX-Sensor.
Program in One Operation
1. Follow the steps in Auto Create to select MX-Sensor to enter the Programming
function. The OBD mark will appear on the right side of the screen (Figure 5-18).