User's Manual

3. Driver Setup & Network Configuring

3.1 Driver Setup

In order for the Pass-Thru Device to operate correctly with the

re-flashing and diagnostic applications on the target PC, you will

need to first install the MaxiFlash Elite J2534 device driver onto the

PC that will control the device.

To setup the J2534 Pass-Thru device driver, you will need the

followings:

 CD with the device driver program

 PC or laptop with USB ports

 J2534 Pass-Thru reprogramming tool

 USB cable

NOTE: The following steps may vary depending on the

operating system or components that are installed on your

computer, but in general this is the standard installation

process.

1) Insert the driver installation CD to your PC and open the CD

folder.

2) Double click on “Autel Run.exe” item.

3) Click the MaxiFlash Elite icon in the MaxiSys PC Suite

screen.

4) Select the installation language and the installation wizard

will load momentarily.

5) Follow the wizard instructions on the screen and click “Next”

to continue.