Use and Care Manual

57
The Component Test function allows initiating a leak test for the
vehicle's EVAP system. The scan tool itself does not perform the
leak test, but commands the vehicle's on-board computer to start
the test. Different vehicle manufacturers might have different
criteria and methods for stopping the test once it has been started.
Before starting the Component Test, refer to the vehicle service
manual for instructions to stop the test.
1) Use the UP/DOWN scroll button to select Component Test from
Diagnostic Menu and press the OK button. (Figure 5.4)
2) Wait for the scan tool to display the Component Test menu.
Figure 5.46
3) If the test has been initiated by the vehicle, a confirmation
message will be displayed on the screen.
Figure 5.47
 Some vehicles do not allow scan tools to control vehicle
systems or components. If the vehicle under test does not
Component Test
Evap Leak Test
?
Component Test
Command Sent!
Press any key to con.