Use and Care Manual

3) Press the OK button to save your selection and return to

previous menu.

Status Beep Set

This function allows you to turn on/off the build-in speaker for the

LEDs in diagnostic testing. Different audio tone corresponds to

different LED lamp. This function is invaluable when working in

bright areas where LED illumination alone is not sufficient.

1) From System Setup screen, use the UP/DOWN scroll button to

select Status Beep Set and press the OK button.

2) From Status Beep Set menu, use the UP/DOWN scroll button to

select Beep ON or Beep OFF to turn on/off the beep.

Figure 3.9

3) Press the OK button to save your selection and return to previous

menu.

Tool Self-test

The Tool Self-test function checks if the display, LED lamps and

keyboard are working properly.

A. Display test

The Display Test function checks if the LCD display is working

normally.

Status Beep Set 1/2

 Beep ON

 Beep OFF ?