Use and Care Manual

19
The monitors for compression ignition engines show as below:
Compression IGN Required Monitors
□
MIS
√
BP
√
FUEL
√
EGS
√
CCM
√
PM
√
HCCAT
√
EGR
√
NCAT
3) Allowed INC Monitors
From Configure Monitors screen, use the UP/DOWN scroll button to
select Allowed INC Monitors, and press the OK button.
Emissions tests vary depending on the geographic or regional area in
which the vehicle is registered. So the scan tool provides a more
flexible way to meet different standards, which allows the user to
select 0, 1, 2, 3 „not complete‟ monitors in test.
4) Reset Factory Default
From Configure Monitors screen, use the UP/DOWN scroll button to
select Reset Factory Default, and press the OK button.
It will restore the default configuration settings, which are compatible
with most vehicle inspection programs, but it will also delete any
customized settings.
The tool will display an information message to ask for your
confirmation. Select Yes to proceed and No to exit without change.
Unit of Measure
 Metric is the default measurement unit.
1) From System Setup screen, use the UP/DOWN scroll button to
select Unit of Measure and press the OK button.