Instructions / Assembly

31
 Review previously stored data thoroughly before erasing.
Figure 5.1
 If no data is stored in the scan tool, above prompt will not
show up.
8） If you wish to erase the data, press the OK button; if you do not
want to erase the data, press ESC to exit or use LEFT/RIGHT
button to select NO and press OK to continue.
9） View a summary of system status (MIL status, DTC counts,
Monitor status) on screen. (Figure 5.2 ) Wait a few seconds or
press any key for Diagnostic Menu (Figure 5.4) to come up.
Figure 5.2
 If more than one module is detected, you will be prompted to
select a module before testing.
System Status
MIL Status ON
Codes Found 6
Ignition Type Spark
Monitors N/A 3
Monitors OK 3
Monitors INC 5
Diagnostic
Erase previously
stored data to save
data from this test?
YES NO