Instructions / Assembly

 A plastic DLC cover may be found for some vehicles and you

need to remove it before plugging the OBD2 cable.

3) Plug OBD II cable to the vehicle‟s DLC.

When the scan tool is not connected to a vehicle, it can be powered

in the other three ways.

Auto power-off

Solely powered up by Li-ion battery, the tool will automatically turn

off after 15 minutes of inactivity.

Li-ion battery charging

You can charge your Li-ion battery by connecting it to an external

power adapter, by connecting it to the vehicle‟s DLC or by

connecting it to a USB port on your computer. The tool displays a

battery icon in the upper-right corner of the screen to show

approximately how much charge is left.

 Using a Power Adapter

If you're using an external power adapter, connect the tool to the

adapter. Then plug the adapter into a working electrical socket.

 Using your computer

If you want to charge the tool using your computer, make sure

that your computer is turned on, it isn't sleeping (refer to the

computer's manual to find out how to turn sleep off), and that the

USB you connect the tool to provides power. Also, make sure to

use the high-powered USB ports which are typically found on the

computer itself ----- not on your keyboard, which is low-powered.

NOTE: If using a portable computer, make sure it is plugged into

power and that the lid or display is open because if the lid is

closed the computer may go into either standby, sleep, or

hibernation mode and the tool will not charge.