User's Manual
Table Of Contents
- Pagina 1
- Pagina 2
- Pagina 3
- Pagina 4
- Pagina 5
- Pagina 6
- Pagina 7
- Pagina 8
- Pagina 9
- Pagina 10
- Pagina 11
- Pagina 12
- Pagina 13
- Pagina 14
- Pagina 15
- Pagina 16
- Pagina 17
- Pagina 18
- Pagina 19
- Pagina 20
- Pagina 21
- Pagina 22
- Pagina 23
- Pagina 24
- Pagina 25
- Pagina 26
- Pagina 27
- Pagina 28
- Pagina 29
- Pagina 30
- Pagina 31
- Pagina 32
- Pagina 33
- Pagina 34
- Pagina 35
- Pagina 36
LIKTCNA0Page 2
1.1 Conformity
Each KTC radio remote control complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
System must be installed by a licensed technician and in accordance with all relevant local,
state/provincial and federal regulations, including but not limited to NEC, OSHA, CE etc.
1.2 Applications
1.3 General warnings
All machines must undergo a risk analysis; therefore it is necessary to evaluate, within the limits of this analysis,
if the machine can be radio remote controlled.
The machine producer and/or the person who decides upon radio remote control use and installation is
responsible for this analysis.
Autec cannot be held responsible if the risk analysis is not carried out correctly.
To guarantee correct radio remote control operation, all current regulations regarding safety at work and
accident prevention should be respected. All current user country national laws regarding the use of both the
machine and the radio remote control MUST ALWAYS be respected.
Autec cannot be held responsible if the radio remote control is used in unlawful working conditions.
If a fault or breakdown occurs in the KTC, do not use the KTC until the problem has been completely
resolved.
When damaged parts need to be replaced, qualified personnel or service representative have to carry out this
operation using original Autec spare parts.
Autec will not accept any responsibility if the KTC is:
- installed for applications which are not authorised
- used in working conditions which do not conform to the relevant regulations
- is not installed by qualified personnel
Autec cannot be held responsible if the radio remote control is installed on applications
that are different from those permitted
- Telemetry, signal systems
- Transmission of commands for machines which lift and move material
- Transmission of a safety command
WARNING: Follow the instructions carefully on pages 8,9 and 10
FORBIDDEN APPLICATIONS
- Machines installed in environments where equipment with explosion-proof
characteristics are being used
- Transmission commands for machines which lift and transport people
:
PERMITTED APPLICATIONS:
WARNING: Connect the POWER SUPPLY to the KTC only by means of a Safety Transformer
(or corresponding IEC 60204-32 paragraph).
Permission to install and to use the KTC is to be given exclusively to qualified personnel.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.