User's Manual
Table Of Contents
- Pagina 1
- Pagina 2
- Pagina 3
- Pagina 4
- Pagina 5
- Pagina 6
- Pagina 7
- Pagina 8
- Pagina 9
- Pagina 10
- Pagina 11
- Pagina 12
- Pagina 13
- Pagina 14
- Pagina 15
- Pagina 16
- Pagina 17
- Pagina 18
- Pagina 19
- Pagina 20
- Pagina 21
- Pagina 22
- Pagina 23
- Pagina 24
- Pagina 25
- Pagina 26
- Pagina 27
- Pagina 28
- Pagina 29
- Pagina 30
- Pagina 31
- Pagina 32
- Pagina 33
- Pagina 34
- Pagina 35
- Pagina 36
C Programming
There are eight dip switches for programming in the transmitting and receiving modules.
Operational functions and working frequencies may be programmed.
The group of eight dip switches found in the module is necessary for programming some operations (see
C.1)and setting the operating frequency (see C.2).
The other group of four dip switches must be set as indicated in C.1.
Before programming the dip switch remove:
- the transmitting module- interface card sandwich in the transmitting unit (see procedure B.2)
-the receiving module in the receiving unit (see procedure B. 3)
The group of 8 dip switches present in the radio module of the transmitting unit must be set
in the same manner as the group of 8 dip switches (excluding DIP 1) present in the radio
module of the receiving unit, when any kind of programming is carried out.
The dip switches must be programmed by qualified personnel. During these operations the
unit which is being used must not be connected to the power supply.
Group of 8
dip switches
Group of 4
dip switches
LIKTCNA0Page 26