User's Manual
Table Of Contents
- Pagina 1
- Pagina 2
- Pagina 3
- Pagina 4
- Pagina 5
- Pagina 6
- Pagina 7
- Pagina 8
- Pagina 9
- Pagina 10
- Pagina 11
- Pagina 12
- Pagina 13
- Pagina 14
- Pagina 15
- Pagina 16
- Pagina 17
- Pagina 18
- Pagina 19
- Pagina 20
- Pagina 21
- Pagina 22
- Pagina 23
- Pagina 24
- Pagina 25
- Pagina 26
- Pagina 27
- Pagina 28
- Pagina 29
- Pagina 30
- Pagina 31
- Pagina 32
- Pagina 33
- Pagina 34
- Pagina 35
- Pagina 36
LIKTCNA0 Page 23
Carry out the opening described
in procedure B.1.
Carry out the closure described
in procedure B.1.
Remove the module and the
card from the unit to be replaced
(see relevant replacement).
Insert the modules and cards
removed from the old unit, in the
replacement unit.
Replacement of the only
case
Replacement
of the case
and base
EE
With the help of a screwdriver
move the two catches on the
bottom of the case, as shown in
the figure.
Raise (A) and remove (B) the
case bottom, starting from the
side from which the catches
have been moved.
Extract the base, widening the
lower edge (E) slightly.
Reposition (C) first one side of
the case bottom, then lightly
push the other side (D) into its
correct position.
Insert the base firstly into the
upper and then into the lower
part, slightly widening the lower
edge (E) in order to pass the
connector.
B.5 Replacement of the case or/and base
Disassembly Assembly
DD
AA
BB
CC