User's Manual

LIKTCNA0 Page 11
4.1 Maintenance warnings
The transmitting and the receiving units should always be completely shut using the appropriate strip.
All control and maintenance interventions carried out on the radio remote control must be verified and recorded
by the person in charge of carrying out maintenance on the machine.
ROUTINE MAINTENANCE
The following instructions allow to maintain the radio remote control in a perfect condition, guaranteeing it to
function safely and correctly for a long period.
Special applications may need more specific routine maintenance interventions to be carried out at different
periods.
These instructions do not in any case substitute the norms and laws that regulate work safety, nor do they limit
the responsibility of the purchaser and user of the radio remote control.
All given instructions must be followed correctly each time the machine and the radio remote control are
started.
Transmitting unit
It is recommended every day to:
1. remove dust or accumulations of other material from the transmitting unit. Never use solvents or
flammable/corrosive materials to clean, and do not use high pressure water cleaners or steam cleaners.
2. store the transmitting unit in clean and dry areas.
3. make sure that the transmitting unit gaskets, joystick bellows, selectors caps and pushbuttons are intact, soft
and elastic
Any fault should be repaired by authorised Autec personnel (contact Service), using
original Autec spare parts only.
During all ordinary and extraordinary maintenance operations carried out on the KTC and
on the system in which it is installed, switch off the power supply to the electrical panel,
both in the transmitting and in the receiving unit.
Before carrying out maintenance and/or diagnostics it is recommended to replace the
battery with a charged one and ensure the efficiency of the START key.
Routine maintenance in accordance to the instructions given in this manual is fundamental
for the safe use of the radio remote control.
Read and strictly respect the warnings given in the battery charger manual in order to
lengthen the life of the battery itself.
After each maintenance intervention, always make sure that only the expected
manoeuvres are carried out when the relative commands are sent by the transmitting unit.
If irregularities are noted while carrying out routine maintenance, put the "machine+radio
remote control" system out of order, following the indications given (see “Receiving unit
diagnostic”)