User's Manual

Page 2 of 16 2 - Introduction LIMJNMA0
English
2 INTRODUCTION
Industrial radio remote controls of the Modular se-
ries are used to command machines from a dis-
tance. Each industrial radio remote control is made
up of a portable transmitting unit, from which the
user can remotely control the machine, and a re-
ceiving unit installed on board the machine itself.
The transmitting unit uses radio frequencies to
transmit a coded message which contains a value
called address. Each receiving unit can only de-
code the messages coming from a transmitting unit
with the same address.
This excludes the possibility of an interference ac-
tivating any system function. If the radio frequency
transmission is disturbed, incorrect or interrupted,
the receiving unit autonomously stops the whole
system.
Each Modular series radio remote control complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party re-
sponsible for compliance could void the user’s authority to operate
the equipment.
Autec cannot be held responsible if the radio remote control is in-
stalled on applications that are different from those permitted:
PERMITTED USES
Material lifting machines (construction cranes, industrial bridge
cranes, machines for moving material in general, . . . ).
FORBIDDEN USES
Machines installed in areas where equipment with explosion-proof
characteristics are being used.
Machines for moving, raising and transporting people.
Receiving
unit
Transmitting
unit
!
!