User's Manual

Page 2 2 - Introduction LILKNPA1-01 - AmEn.fm
2 INTRODUCTION
Receiving
unit
Transmitting
unit
Industrial radio remote controls of the Light series
are used to control machines from a distance. Each
industrial radio remote control is made up of a por
-
table transmitting unit, from which the user can re-
motely control the machine, and a receiving unit in-
stalled on board the machine itself.
The transmitting unit uses radio frequencies to
transmit a coded message which contains a value
called address. Each receiving unit can only de
-
code the messages coming from its own transmit-
ting unit with the same address.
This excludes the possibility of an interference ac-
tivating any system function. If the radio transmis-
sion is disturbed, incorrect or interrupted, the re-
ceiving unit autonomously stops the whole system.
Each radio remote control complies with Part 15 of the FCC rules.
Operation is subject to the following conditions:
- this device may not cause a harmful interference, and
- this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Autec cannot be held responsible if the radio remote control is installed on applica-
tions that are different from those permitted:
PERMITTED USES
Hoisting machines (construction cranes, bridge cranes, machines for material
handling in general,…).
FORBIDDEN USES
Machines installed in areas where equipment with explosion-proof character-
istics is required.
Machines for moving, raising and transporting people.