User's Manual
Table Of Contents
Page 15
LIMKPNA0
8
PROGRAMMING
The group of eight dip switches found
in the module is necessary for
programming some operations and
setting the operating frequency.
The programming set in the other
group of four dip switches must never
be modified.
DIP SWITCHES ON E16STXUS1 RADIO TRANSMITTING MODULE
Group of 8 dip switches
!
These eight dip switches must be programmed in the same manner as
the group of 8 dip switches (excluding DIP 1) present in the radio
module of the receiving unit (see manual).
Group of 4
dip switches
Group of 8
dip switches
(*) With the MK12 transmitting unit the dip switch should be at ON.
DIP POS. DESCRIPTION
ON
The transmitting unit never switches off automatically
1 (*)
OFF
The transmitting unit switched on without movement commands entered
switches off after approx. 3,5 minutes
ON
Deactivated of low battery warning from horn on machi ne
2
OFF
Activation of low battery warning from horn on machine
ON
With DIP 8 OFF automatic scan mode of the frequencies in the
915 - 928 MHz
3
OFF
With DIP 8 OFF automatic scan mode of the frequencies in the
902 - 915 MHz
3 - 7 ON/OFF
With DIP 8 ON see “Appendix: Frequency Table”
ON
Manual selection of frequencies with
DIP 3 - DIP 7 (see “Appendix: Frequency Table”)
8
OFF
Automatic scan mode of frequencies in the band selected with DIP 3
(DIP 4 – DIP 7 not relevant)
!
The dip switches must be programmed with the battery removed from
the transmitting unit and can be done only by authorised personnel.
The incorrect closure of the transmitting unit can compromise seal
between the casings and thereby the protection grade from dust and
water.