User's Manual

With the transmitting unit started
(blinking green LED):
- press the START pushbutton
(a) and keep it pressed,
- press the STOP pushbutton (b),
- release the START pushbutton.
Unlock the STOP pushbutton by
turning it as shown in the photo
and repeat the starting
procedure.
1
2
N.B.: During the work
frequency changing
process, the receiving unit
loses radioelectric
connection with the
transmitting unit. After
starting, some seconds may
be necessary to reset
connection, therefore keep
the START button pressed
for about 8÷10 seconds.
The radio frequency of AUTEC radio remote controls is included in the group of
frequencies permitted by regulations that are current at the moment of radio
remote control entry onto the market.
Each radio remote control is programmed by the producer in the AUTOMATIC scan
mode (producer's standard programming) or MANUAL selection mode.
MANUAL SELECTION MODE
When operating in the MANUAL selection mode it is possible to work at a specific
frequency that must be set manually by programming the dip switches in the radio
modules (see “Settings” on page 13).
To set or modify this operation mode contact personnel that have been authorised
by Autec.
AUTOMATIC SCAN MODE
When operating in the AUTOMATIC scan mode it is possible to operate at a specific
frequency, which can be changed in case of interference or conflict with other radio
equipment using the “Changing the operating frequency” procedure.
This mode avoids internal interventions on the transmitting unit and the receiving unit.
FREQUENCIES
7
Working frequency change process
Page 14
LIMKPNA0
a
b