User's Manual

To recharge a flat battery, proceed as
follows:
1. Insert the battery into its proper
battery charger, which should be
positioned in an area having a
temperature of between +5°C and
+45°C. The battery now starts
charging, a state signalled by the
lighting up of the “CHARGE” pilot
light.
After a maximum of 3 hours the
"CHARGE" indicator switches off: the
battery is fully charged. Remove the
battery from the charger (if the battery
is not removed, charging continues in
maintenance mode).
2.
!
The STOP button
should be used when it
is necessary to stop the
machine immediately in
order to check any
danger condition.
STOP
To stop the machine immediately, press
the STOP button.
To start working again, after having
made sure that the working conditions
are safe, turn the STOP button in the
direction indicated to deactivate it and
repeat the starting procedure.
Page 13
SWITCHING OFF
LIMKPNA0
The transmitting unit should be switched off
each time work is stopped by turning the
ignition key to "O" and extracting it (always put
the key in a safe place).
The unit may also switch off if the battery is not
sufficiently charged and/or when the radio remote
control is not used for more than 3,5 minutes (set
DIP nr. 1: refer to paragraph 8 "Programming").
BATTERY