Instruction Manual
9 Instructions for the User
The chapter "Instructions for the User" in "Part A" of the Instruction Manual contains the
warnings for the use that add to those provided in this chapter. Therefore, please refer to
that part of the Manual.
The following instructions refer to general usage situations for the SK4 Transmitting Unit, and
indicate how user should or should not behave when using the Unit: these do not cover any
possiblerisksituationand/ordrawbackthatmaydependonspecicapplicationsofAutec
Radio Remote Controls.
However, instructions given in the following paragraphs do not replace nor complete the
instructions that must be provided to the User by the Manufacturer of the Machine where
an Autec Radio Remote Control (to which the SK4 Transmitting Unit belongs) is installed.
9.1 Usage restrictions
If the Radio Remote Control User wears electronic devices (by way of
example: pacemaker, implantable cardiac debrillator, hearing aids), the
Transmitting Unit must be kept at least 15 cm away from those devices
when in use.
9.2 User behaviour
Besides the instructions contained in the General Part (Part A) of the Instruction Manual,
when using the SK4 Transmitting Unit, the User must:
- observe and comply with all instructions and warnings provided by the Machine
Manufacturer;
- observeandcomplywithallinstructionsandwarningsprovidedbytheInstaller;
- observe and comply with all instructions and warnings provided by the Person responsible
fortheMachinecommissioningormakingtheMachineavailableforwork;
- observe and comply with all instructions and warnings provided in the Radio Remote
ControlManual;
- observe and comply with all applicable Laws, Regulations and Standards, even local.
- follow and put into practice the working instructions he received, and/or those he must
beawareofbecauseofhisworkandhistasks;
- avoid using the Radio Remote Control if he has not been properly trained and prepared,
andifhehasnotbeenqualiedforitsusebythePersonresponsibleforthework;
- makesurethattheTransmittingUnitandtheReceivingUnitarewholeandworkperfectly;
- make sure that the Machine reacts correctly to the commands activated by the Autec
RadioRemoteControl;
- not perform any operation if the tests mentioned in the previous two points did not give
positiveresults;
28
LIUSK4N01_eng-01
Instructions for the User
AUTEC - AIR SERIES